SteelTemplate

It is worth to use it in any finish, because the roof is a structure that deforms under the influence of wind and snow lying on it. Using the grid, reduces the risk of cracks or even bursting finish material to the taper. Read more about the grates in the article: grid under the finish. Bevels attic can be finished in several ways: * Plasterboard, whose core is stuck on both sides of carton. Dry to the premises it is recommended that boards simply(gray), and the wet - boards (with a green print or all green) with increased water resistance. To the premises shall be dry plate and those with higher humidity. The thickness of plates for finishing slants should not be less than 12.5 mm. The most commonly used panels are 120 cm in width and from 200 to 300 cm in length. Their transport to the attic and cut can therefore be difficult. Therefore, some manufacturers have offered lower plate: width of 60 to 90 cm and a length of 130 cm. Can easily bring them under his arm, even after the steep stairs to the building. However, if there is more connections and thus increases the consumption of filler and reinforcing tapes.